Rox riser copy

[anthony29040]

how do they do it ordered these from hong kong of ebay £23 posted 10 days later they arrive.they fit perfect and i would say there a copy of the speed fx rox risers,really good quality.and stainless bolts. (thumbs)

2016-05-1113.07.11.jpg (23.08 KiB) Viewed 2051 times

28MM Bar Clamp Riser Taper Handlebar For KTM 950/990 ADV Silver D
28MM Bar Clamp Riser Taper Handlebar For KTM 950/990 ADV Silver D
i am struggling with the link but copy and paste this into the search on ebay

[herman]

Linky please B)

[anthony29040]

Linky please B)

try this mate 28MM Bar Clamp Riser Taper Handlebar For KTM 950/990 ADV Silver D in ebay search if its for your s10 you have to mess about with your hoses wasn't so bad on mine because i have lowered the forks in the yokes by 12mm.cheers tony

[[email protected]]

how do they do it ordered these from hong kong of ebay £23 posted 10 days later they arrive.they fit perfect and i would say there a copy of the speed fx rox risers,really good quality.and stainless bolts. (thumbs)

2016-05-1113.07.11.jpg

28MM Bar Clamp Riser Taper Handlebar For KTM 950/990 ADV Silver D
28MM Bar Clamp Riser Taper Handlebar For KTM 950/990 ADV Silver D
i am struggling with the link but copy and paste this into the search on ebay

I've ordered these in the past, I'd agree, good quality fast delivery and good price.

[The Sarge]

+ 1 (thumbs)

[cowling]

Look great them Tony, at a bargain price too.
No wonder our industry's are looking bleak.
They will help you get the front wheel airborne.

Do u not fancy the adv rally in a few weeks ?

[anthony29040]

Look great them Tony, at a bargain price too.
No wonder our industry's are looking bleak.
They will help you get the front wheel airborne.

Do u not fancy the adv rally in a few weeks ?

where is it send me the details,got a bank holiday coming up. (thumbs)

[ianrd]

+1 also bought a set, Rockrisers without the sticker or the price

[daytona-supersport]

Yep, far cheaper and quicker to buy from the far east. Most of this stuff is made out there anyway. I used to get top quality mould and press tooling made for a fraction of the UK cost and made in under half the time.

PS, Just got some NOS brass fuel taps from America. Two taps delivered about £25.00. Cost of one reproduction tap in the UK, around £35.00 each. :laugh: :laugh:

[anthony29040]

Yep, far cheaper and quicker to buy from the far east. Most of this stuff is made out there anyway. I used to get top quality mould and press tooling made for a fraction of the UK cost and made in under half the time.

PS, Just got some NOS brass fuel taps from America. Two taps delivered about £25.00. Cost of one reproduction tap in the UK, around £35.00 each. :laugh: :laugh:

i must admit i do feel a bit guilty about buying from out side the UK but i have a bit of a tight budget so i have to keep an eye on the pennies.cheers T