As per title
Engine bars wanted please. don't mind if paint flaking or cracking .
getting them powder coated.
Thanks
Big Al
1150 Gs engine bars wanted
Re: 1150 Gs engine bars wanted
Hi BigAl,
I have some engine bars for a r21 year 2001 r1150gs I took off my bike as I wanted a full upper and lower set I think they are Fehling make.
Let me know if these are of interest to you?
They are solid and appear undamaged with all mounting brackets but have a bit of surface rust on them.
I have some engine bars for a r21 year 2001 r1150gs I took off my bike as I wanted a full upper and lower set I think they are Fehling make.
Let me know if these are of interest to you?
They are solid and appear undamaged with all mounting brackets but have a bit of surface rust on them.
Re: 1150 Gs engine bars wanted
Hi quaycrest.
I've got a rugged roads plate right where the connecting bar fits on the bars.
Any chance of some close up photos of that area please, so I may figure the plate to bars out.
Thanks.
Al.
I've got a rugged roads plate right where the connecting bar fits on the bars.
Any chance of some close up photos of that area please, so I may figure the plate to bars out.
Thanks.
Al.
Re: 1150 Gs engine bars wanted
Hi Al,
These are the only other images I have of the bars as they are now off the bike.
These are the only other images I have of the bars as they are now off the bike.
- Attachments
-
- rps20190316_144804.jpg (118.53 KiB) Viewed 2845 times
Re: 1150 Gs engine bars wanted
Hi Big Al,
The bars mount at three points one under the tank onto the front subframe, one just above the rear of each cylinder and the last one is the mount bracket just above the exhaust cross pipe. So no fixings to underside of bashplate.
The bars mount at three points one under the tank onto the front subframe, one just above the rear of each cylinder and the last one is the mount bracket just above the exhaust cross pipe. So no fixings to underside of bashplate.
Re: 1150 Gs engine bars wanted
Hi quaycrest.
I have a crud catcher mounted on the front cover.
How close is the joining bracket to the front engine cover please.
Was wondering if the bars would fit behind the cover.
Thanks
Al
I have a crud catcher mounted on the front cover.
How close is the joining bracket to the front engine cover please.
Was wondering if the bars would fit behind the cover.
Thanks
Al
Re: 1150 Gs engine bars wanted
Hi Al,
From memory and looking at the images I provided I am sure its pretty close to the engine with little space between the bracket and block. Would the crud catcher fit over the bracket or could longer stand-offs be made?
From memory and looking at the images I provided I am sure its pretty close to the engine with little space between the bracket and block. Would the crud catcher fit over the bracket or could longer stand-offs be made?