wk 400 trail
wk 400 trail
Hello people,
New to the site and new to wk motorcycles
I have a problem. the bike starts and rides ok, but has its own idea to just cut out when going down the gears or stopped at crossroads, starts up again no problems. seen something about fuel cap gasket, popped the cap and road it, the same problem removed the spark plug looks good ...looks and feels like electrical as its a sudden cut-out
Any ideas?
also where to get parts for this bike, i don't mean service parts i mean everything else, coils etc
regards
shane
New to the site and new to wk motorcycles
I have a problem. the bike starts and rides ok, but has its own idea to just cut out when going down the gears or stopped at crossroads, starts up again no problems. seen something about fuel cap gasket, popped the cap and road it, the same problem removed the spark plug looks good ...looks and feels like electrical as its a sudden cut-out
Any ideas?
also where to get parts for this bike, i don't mean service parts i mean everything else, coils etc
regards
shane
-
- Posts: 1822
- Joined: Sun Dec 06, 2015 4:13 pm
- Has thanked: 3 times
- Been thanked: 126 times
Re: wk 400 trail
Hi Shane welcome to the site , did you check the side stand is not loose it may be activating the kill switch relay?
Re: wk 400 trail
They all appear to suffer with it. On long straights , especially when air temp is warm, mine will cut out on slowing to a roundabout or junction ramp.
If lucky and fast enough itll bump and start, if not will start at first prod of switch.
Fuel lock, there's no breather pipe.
There's a wk400 owners thread on here. A few pages in and a few have tried a few things
Mine has sidestand switch disabled and still does it.
One piece of advice. The inside of the gear lever is Sharp. Mine went over and it punctured a hole in the engine casing. Near 3 month wait for another. Make a plate for the vulnerable part of xasing and grind the sharp edge on lever back
If lucky and fast enough itll bump and start, if not will start at first prod of switch.
Fuel lock, there's no breather pipe.
There's a wk400 owners thread on here. A few pages in and a few have tried a few things
Mine has sidestand switch disabled and still does it.
One piece of advice. The inside of the gear lever is Sharp. Mine went over and it punctured a hole in the engine casing. Near 3 month wait for another. Make a plate for the vulnerable part of xasing and grind the sharp edge on lever back
"The trails of the world be countless, and most of the trails be tried.
You tread on the heels of many, till you come where the ways divide.
And one lies safe in the sunlight, and the other is dreary and wan, Yet you look aslant at the Lone Trail, and the Lone Trail lures you on....
....Bid good-bye to sweetheart, bid goodbye to friend, The Lone Trail, the Lone Trail, follow to the end.
Tarry not, and fear not, chosen of the true;
Lover of the Lone Trail, The Lone Trail waits for you"
You tread on the heels of many, till you come where the ways divide.
And one lies safe in the sunlight, and the other is dreary and wan, Yet you look aslant at the Lone Trail, and the Lone Trail lures you on....
....Bid good-bye to sweetheart, bid goodbye to friend, The Lone Trail, the Lone Trail, follow to the end.
Tarry not, and fear not, chosen of the true;
Lover of the Lone Trail, The Lone Trail waits for you"
Re: wk 400 trail
"The trails of the world be countless, and most of the trails be tried.
You tread on the heels of many, till you come where the ways divide.
And one lies safe in the sunlight, and the other is dreary and wan, Yet you look aslant at the Lone Trail, and the Lone Trail lures you on....
....Bid good-bye to sweetheart, bid goodbye to friend, The Lone Trail, the Lone Trail, follow to the end.
Tarry not, and fear not, chosen of the true;
Lover of the Lone Trail, The Lone Trail waits for you"
You tread on the heels of many, till you come where the ways divide.
And one lies safe in the sunlight, and the other is dreary and wan, Yet you look aslant at the Lone Trail, and the Lone Trail lures you on....
....Bid good-bye to sweetheart, bid goodbye to friend, The Lone Trail, the Lone Trail, follow to the end.
Tarry not, and fear not, chosen of the true;
Lover of the Lone Trail, The Lone Trail waits for you"
Re: wk 400 trail
Hi Shane, welcome to the site and the world of WK. Hopefully with two mods this can be fixed as mine used to do the same and no longer does any cutting out during a ride.................the first is to do a fuel cap mod, check the WK thread on here as it has the key steps and pictures required, the gasket in the fuel cap may need trimming and a hole drilled to ensure no vacuum forms.............the next is more tricky and involves checking and possibly adjusting the TPS setting with a meter this is also on the WK thread. Suggest you try the first and come back on here after if you need help on the TPS. May be best to use the WK thread rather than this one to keep things tidy. These are great bikes in my view and with some fettling they seem very capable and reliable, ive got 6000 miles on mine and once the bits ive explained plus a few other things were sorted its been great to ride, basic and old school but then so am i.................Shane58 wrote: ↑Wed Jun 27, 2018 10:38 pm Hello people,
New to the site and new to wk motorcycles
I have a problem. the bike starts and rides ok, but has its own idea to just cut out when going down the gears or stopped at crossroads, starts up again no problems. seen something about fuel cap gasket, popped the cap and road it, the same problem removed the spark plug looks good ...looks and feels like electrical as its a sudden cut-out
Any ideas?
also where to get parts for this bike, i don't mean service parts i mean everything else, coils etc
regards
shane
In terms of parts then wkbikes.com have a parts department, many items are in stock but not all, if its not in stock you could wait up to 3 months , some service items can be found elseware
-
- Posts: 33
- Joined: Wed Jun 12, 2019 9:23 pm
- Location: Rutland
- Has thanked: 1 time
- Been thanked: 1 time
Re: wk 400 trail plug in for fault code
Doe any one know if there is a plug in for clearing fault codes please
Wk 400 trail 2016
Wk 400 trail 2016
-
- Posts: 33
- Joined: Wed Jun 12, 2019 9:23 pm
- Location: Rutland
- Has thanked: 1 time
- Been thanked: 1 time
-
- Posts: 33
- Joined: Wed Jun 12, 2019 9:23 pm
- Location: Rutland
- Has thanked: 1 time
- Been thanked: 1 time
Re: wk 400 trail
My WK 400 trail used to stall at junctions ,clean air flow senser now doesn't do it anymore.
-
- Posts: 191
- Joined: Wed Dec 14, 2016 7:31 am
Re: wk 400 trail
Welcome to the Mad House and get out there and Dirty.
Always liked the WK Dirt style offerings and Trail Wise even used the 125 for a lot of the women shorter riders on there courses and really wragged them about without issues.
As mentioned above apart from welcome posts in this thread, any questions would be better answered in the relevant forum sections and threads.
Enjoy the freedom a bike gives...
Always liked the WK Dirt style offerings and Trail Wise even used the 125 for a lot of the women shorter riders on there courses and really wragged them about without issues.
As mentioned above apart from welcome posts in this thread, any questions would be better answered in the relevant forum sections and threads.
Enjoy the freedom a bike gives...
-
- Posts: 1781
- Joined: Thu Apr 14, 2011 8:18 pm
- Location: East Lancs
- Has thanked: 201 times
- Been thanked: 273 times
Re: wk 400 trail
Nearly 18mths since Shane's first & only post either he cured the problem or he's stuck somewhere in the middle of nowhere?
***just like Britney Spears oops I did it again……sold the Scrambler & as of now there may not be a replacement***