Pannier frame loops - precurved made up

[Glenn_G]

Hi,

I'm looking to make another set of round steel tube rear pannier frames for my wk400, to take soft panniers.

My last attempt with a pipe bender/welder wasn't very pretty or strong.

So anyone know where I can buy pannier frame loops (OD~20mm & 2/3mm wall thickness) already precurved welded into a rectangular hoops.

I can then make weld up some support tubes to attach them onto my bike.

Cheers

[cozi70]

http://holan.pl/en/nomada-racer-pannier ... racer.html

http://expeditioncases.pl/surowe-ramki- ... -p-14.html

[chubbyhooker]

[img][/

04C94386-766C-48E9-95E8-F5A255B22624.jpeg (244.51 KiB) Viewed 4029 times

img]i made mine from 2 cafe chairs

[minkyhead]

my skill set is not up to tubing ..but ive had decent results using light box section and flat bar ..much easier to work with than tubing and they are strong ..

aaa by minkyhead56, on Flickr

aaaaaaa by minkyhead56, on Flickr

DSC_0793 by minkyhead56, on Flickr

[diggermanbob]

If you put in pannier frames on eBay there is a set of hoops listed ,

[Glenn_G]

cozi70 your 2nd link looks promising thanks

Chubbyhooker that's good recycling of chairs

Minkyhead thanks but I'm keen to learn/practise more with tubing as lighter. Looks strong.

[Glenn_G]

'If you put in pannier frames on eBay there is a set of hoops listed '

diggermanbob so far only ones I can see are either too old/rusty, different diameter tubing or need some work - in which case it may be easier to start from scratch ... good idea though, ta

[hotbulb]

Minkyhead...... is the first set you picture wearing its woolly knitted jacket?

[minkyhead]

looks that way ,,its anti slip matting from poundland . high spec stuff indeed

[Morph]

https://shop.touratech.co.uk/pannier-fr ... steel.html

https://shop.touratech.co.uk/pannier-fr ... steel.html