Adventure Bike Rider Forum

Just received 2 ABR stickers for the bike, but they not seem to be sticky (no adhesive). Anyone else had the same issue? - Still they were free.

mine were very hard to peel of the backing as it kept separating but when i got it of it was sticky

Cheers - I'll give them another go

VICTORY!!! took at bit of doing, but it now has pride of place on the bike!

JimboF650 wrote: Just received 2 ABR stickers for the bike, but they not seem to be sticky (no adhesive). Anyone else had the same issue? - Still they were free.

The easiest way to separate the sticker from it's backing is to use the blade of a Stanley knife, i.e. separate them by using the fine edge between the two.
Hope this helps,
Mark.

How do you get these stickers?

Just email your details to Emily address below.

[email protected]

mark1150 wrote:

JimboF650 wrote: Just received 2 ABR stickers for the bike, but they not seem to be sticky (no adhesive). Anyone else had the same issue? - Still they were free.

The easiest way to separate the sticker from it's backing is to use the blade of a Stanley knife, i.e. separate them by using the fine edge between the two.
Hope this helps,
Mark.

No putting it in water is the easiest way and safest.

CRAIGREVO wrote:

mark1150 wrote:

JimboF650 wrote: Just received 2 ABR stickers for the bike, but they not seem to be sticky (no adhesive). Anyone else had the same issue? - Still they were free.

The easiest way to separate the sticker from it's backing is to use the blade of a Stanley knife, i.e. separate them by using the fine edge between the two.
Hope this helps,
Mark.

No putting it in water is the easiest way and safest.

To be honest I wouldn't have even thought of that method as an option, but to be fair I've never found using the Stanley dangerous, I make Mrs H do it for me,
Good tip mate.

how much are they or are the really free?