Search found 75 matches
- Tue Dec 08, 2015 5:03 pm
- Forum: TRAVEL
- Topic: How to tie down a trail bike on a ferry??
- Replies: 27
- Views: 5229
Re: How to tie down a trail bike on a ferry??
On the Pont Aven down to Santander this year, they ferry crew used a heavy duty strap over the seat with a big plastic covered foam pillow, they tighten this strap a lot, so much that I had to stop the deck hand from continuing to ratchet it down when I thought my seat was going to give in under the...
- Wed Dec 02, 2015 9:54 pm
- Forum: TRAVEL
- Topic: How to tie down a trail bike on a ferry??
- Replies: 27
- Views: 5229
Re: How to tie down a trail bike on a ferry??
Buy a couple of long cambuckle straps Cambuckles , cut at about 40cm away from the camlock and form a loop onto each cut end large enough to get your hand through, sew the cut ends of the loop back onto the strap with some strong thread similar to how the camlock is attached to the other end of the ...
- Sun Nov 29, 2015 5:27 pm
- Forum: BIKES
- Topic: Well can we be tempted by electric??
- Replies: 42
- Views: 10112
Re: Well can we be tempted by electric??
Would an electric bike get around the Byways Closed to Vehicles rules? Could that be deemed to be a cycle and be used on bridleways?
- Sat Nov 28, 2015 8:38 pm
- Forum: BIKES
- Topic: Ktm 690r Husky 701
- Replies: 158
- Views: 39901
Re: Ktm 690r Husky 701
Under load it works the other way and compresses the two parts together
- Sat Nov 28, 2015 6:10 pm
- Forum: BIKES
- Topic: Ktm 690r Husky 701
- Replies: 158
- Views: 39901
Re: Ktm 690r Husky 701
If you look at the following youtube clip showing the rekluse install to the 690, at around 2:27 you can see the two inner parts of the clutch with angled ramps.
On overrun, this allows the outer part to ride up and release pressure on the plates.
KTM 690 Rekluse installation
On overrun, this allows the outer part to ride up and release pressure on the plates.
KTM 690 Rekluse installation