Search found 546 matches
- Fri Aug 30, 2019 10:49 pm
- Forum: TECHNICAL
- Topic: Motion Pro bead breaker tyre levers, I am just rubbish?...
- Replies: 18
- Views: 7937
just cut a few timber wedges at different angles and hammer in a few inches apart and this will ease the bead down , dont use wd 40 just soap will work. the tyres are hard and will give way place the wheel on an old car tyre so the tyre can drop down .
- Sun Feb 24, 2019 7:50 pm
- Forum: BIKES
- Topic: Solo touring and off road (e.g. tet), small ADV bike suggestions
- Replies: 83
- Views: 11292
well this small bike touring seems to catching on .I had a ride out this morning small tracks, by way and some back road blasting to 70 mph . my 310 gs is great at this comfy and ok off road. after taking the bike down to morocco and back ,its still in one piece and nothing has fell off. so summer g...
- Sat Feb 23, 2019 10:40 am
- Forum: ACCESSORIES
- Topic: ...the puncture cover up!
- Replies: 12
- Views: 2522
what are you trying to do just adjust pressure, slime will do it but may block the valve . its ok with a garage air line but struggles with a little pump to clear the valve
- Sun Feb 17, 2019 5:08 pm
- Forum: TRAVEL
- Topic: EDC Morocco, Africa, Sept 2019. Open invite for a free On/Off road & desert guided tour.
- Replies: 199
- Views: 40406
any tyre will do when you see what they ride on . mitas are cheap and do the job . I would say dont worry about your rubber .1000 mile is nothing to worry about eo7 or more knobs e09 will do the job . now if you need any advice about shitting and riding a motorcycle I am you man top tip dont try to ...
its the oil slipping the clutch you should change it to semi not full slippy it just to sticky and stays on the plate to much , standard car oil will be fine no posh stuff . its not in there long enough to break down . as for tyres go back to the correct size and the problem will go away . how many ...